Buy (1000 RUB)
Generate QR code
Open Access
Subscription or Fee Access
Colloidal and chemical aspects of increasing the strength of protective and decorative silicate coatings on steel
Abstract
An increase in the mechanical strength of protective and decorative silicate coatings on steel can be achieved by introducing theoretically justified and practically tested surfactants (surfactants) into the coating formulation, providing an increase in wetting and a decrease in interfacial tension at the metal-adhesive interface.
Keywords
adhesion,
cohesion,
surface tension,
Gibb’s energy,
interfacial tension,
heat of evaporation,
protective and decorative coating,
steel
Supporting agencies: The research was conducted within the framework of a grant provided by the Belgorod Regional Entrepreneurship Support Fund under Contract No. 22-IG dated 12/28/2010
About the Authors
V. N. Bogdanov
Belgorod State Technological University named after V. G. Shukhov
Russian Federation
Russian Federation
Bogdanov V. N. — is a leading specialist at the Center for the Transfer of Innovative Technologies, an assistant at the Department of Industrial Ecology
V. A. Peristy
Belgorod State National Research University
Russian Federation
Russian Federation
Peristy V. A. — Candidate of Technical Sciences, Associate Professor of the Department of General Chemistry, Institute of Pharmacy, Chemistry and Biology
Belgorod
A. I. Vezentsev
Belgorod State National Research University
Russian Federation
Russian Federation
Vezentsev A. I. — Doctor of Technical Sciences, Professor, Professor of the Department of General Chemistry, Institute of Pharmacy, Chemistry and Biology
Belgorod
L. F. Peristaya
Belgorod State National Research University
Russian Federation
Russian Federation
Peristaya L. F. — Candidate of Technical Sciences, Associate Professor of the Department of General Chemistry, Institute of Pharmacy, Chemistry and Biology
Belgorod
References
1. Богданов В.Н., Перистый В.А., Везенцев А.И., Корниенко И.Д., Перистая Л.Ф., Воронцова О.А., Козырева Ю.Н. Повышение прочности и влагостойкости силикатных защитных покрытий по металлу // Химическая промышленность сегодня. 2013. № 6. С. 4–11.
2. Корнеев В.И., Данилов В.В. Растворимое и жидкое стекло. СПб.: Стройиздат, 1996. 216 с.
3. Пат. РФ 2.034.810. 1995.
4. Пат. РФ 2.294.947. 2007.
5. Пат. РФ 2.272.820. 2006.
6. Карасев К.И. // Строительные материалы. 1960. № 7. С. 11–12.
7. Агафонов Г.И., Корнеев В.И. // Всесоюзн. хим. общества им. Д.И. Менделеева. 1988. Т. 33. С. 67–71.
8. Агафонов Г.И., Одляницкая В.С., Ицко Э.Ф., Калаус Э.Э. Неорганические покрытия на основе растворов силикатов щелочных металлов // Лакокрасочные материалы и их применение. 1985. № 4. С. 44–48.
9. Перлин В.Д., Строгонов Ю.Д., Казанцева С.И., Водолазкин В.В. Относительное значение силикатного модуля жидкого стекла для получения водо- и атмосферостойких покрытий асбестоцемента. //Строительные материалы. 1982. № 7. С. 21–22.
10. Казанцева С.И., Строгонов Ю.Д. Композиции на основе жидкого стекла// Строительные материалы. 1980. № 11. С. 12–13.
11. Гришина А.Н., Королев Е.В., Хлыстунов М.С. Усадочные деформации радиационно-защитных материалов на основе стекла. // Строительные материалы. 2010. № 6. С. 59–61.
Review
For citations:
Bogdanov V.N., Peristy V.A., Vezentsev A.I., Peristaya L.F. Colloidal and chemical aspects of increasing the strength of protective and decorative silicate coatings on steel. Russian Coatings Journal. 2025;(1-2):49-56. (In Russ.)
Views:
43
JATS XML
Email this article 